Just had my 04 Escape serviced for a lower control arm recall and had the tires rotated while there. Now there is a thumping in the front end. Thoughts on what it might be?

Just had my 04 Escape serviced for a lower control arm recall and had the tires rotated while there. Now there is a thumping in the front end. Thoughts on what it might be? 3 Answers

My 2008 Ford Escape AWD floor matts keep getting soaked. I thought I had fixed it by making sure the sunroof was closed properly, but it has continued. I have tried to figure out where this is coming from and finally after drying them out again I laid under the the vehicle and both on the drivers side in the middle of the front floor area and the passanger side there is a small hole about the size of a dine right in the middle. That would account for the water coming in after rain storms and such, but why would these two holes be there? Was there a drain area there with plugs and they are missing? Can I have a piece of metal welded over them? Don't know why they would be there. Doesn't seem to be a rust issue as it is frim all around these small holes. 7 Answers

Water leak on floors from underneath. There is a small hole size of a dime on both drivers side and passanger side underneath floor matts right in the middle of each. Can I have this repaired with a...

2005 Escape 1 31K miles. Just had a front end aligned. When I break I get knocking near tire. Any ideas what this might be? 5 Answers

When I break I get knocking near tire. Any ideas what this might be?

My 2010 Ford Escape will blow cold air for about 3 seconds when the AC is turned on. I checked the compressor and the clutch will engage for those first couple seconds and then stop completely. I thought it might be low on freon, but when I went to check the low pressure, I got a low pressure reading of 100, which is way too high. My guess is the relay is done or maybe the compressor. Any advice? 1 Answer

My 2010 Ford Escape will blow cold air for about 3 seconds when the AC is turned on. I checked the compressor and the clutch will engage for those first couple seconds and then stop completely. I ...

There is a gurgling in the heater 1 Answer

When the heat is on there is a gurgling in the heater. When the heat is turned up the noise goes away. What can be done?