Rocam engine water bottle pressurized

Asked by GuruZD92M Oct 09, 2017 at 12:13 PM about the Ford Bantam

Question type: Maintenance & Repair

I have a 2006 Bantam rocam engine
that overheats and the water bottle
gets pressurized. Oil and water don't
mix. Engine runs fine other than the
overheating problem. What could be
the solution.

3 Answers
103,215

KenF answered 7 years ago

It could be the head gasket, test it with Block Tester, it will tell you if the pressure is being caused by hydrocarbon combustion gases. (BTW not all blown head gaskets result in cross contamination of water/coolant.)

4 people found this helpful.
Mark helpful
50

Guru2HCRM answered 4 years ago

My ford bantam Rocam is overheating en mixing with oil iwas sending the top to engineering bt still is doing the same thing

5 people found this helpful.
Mark helpful

Your Answer:

Related Questions

  • Rocam engine water bottle pressurized 3 Answers

    I have a 2006 Bantam rocam engine that overheats and the water bottle gets pressurized. Oil and water don't mix. Engine runs fine other than the overheating problem. What could be the solution.

    Ford Bantam

    -

    Maintenance & Repair

  • Water bottle 1 Answer

    My water bottle keep on cracking what can be the reason behind that? Ford bantam 1.6 rocam

    Ford Bantam

    -

    Maintenance & Repair

  • Rocam engine sudden cutoffs 3 Answers

    ave a 2007 Ford Bantam Rocam engine, the car starts ok, idle for about 2minutes or more and thereafter suddenly cuts off. I've replaced the coil pack (non-genuine) and leads but still faced with t...

    Ford Bantam

    -

    Maintenance & Repair

  • Require a Fanbelt routing diagram on a Ford 1.3 Rocam engine without Aircon 2 Answers

    Require a Fanbelt routing diagram on a Ford 1.3 Rocam engine without Aircon

    Ford Bantam

    -

    Maintenance & Repair

  • Ford Bantam 2010 1.3 Rocam Windscreen washer pump & bottle 3 Answers

    Hi everyone . My windscreen washer pump seems to have died and water is leaking out of my windscreen washer bottle too. Is there any way to replace it without taking off the bumper and fender ? Also...

    Ford Bantam

    -

    Maintenance & Repair

Bantam

Looking for a Used Bantam in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

Shortcuts

Search Ford Bantam Questions

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,620
  • #2
    MrRocket12
    Reputation
    1,150
  • #2
    Janus Welgemoed
    Reputation
    1,150
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.