Hi,I have a Ford bantam rocam .The vechile swings but will not start.It will only start if i spray quick start into air intake.Once it starts it will idle and drive.It wont start on its own after that

Asked by WarrenDLange Oct 19, 2017 at 06:38 AM about the Ford Bantam

Question type: Maintenance & Repair

1 Answer
16,935

Guru97FK8 answered 7 years ago

Check the amperage draw on the main starter cable. If the amperage draw is too high on cranking you will not get enough current at the PCM. Check also the starter solenoid cable to the solenoid switch, It runs next to the CPS sensor wiring. separated the two. If the Starter relay has a short circuit in it, you will get cranking, but no spark. I suggest you replace the Starter Relay first.

Mark helpful

Your Answer:

Related Questions

Shortcuts

Search Ford Bantam Questions

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,620
  • #2
    MrRocket12
    Reputation
    1,150
  • #2
    Janus Welgemoed
    Reputation
    1,150
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.