I have a 1989 Camaro RS Cov. My temperature gauge needle is all the way up to the top all the time. Ignition on or off

I have a 1989 Camaro RS Cov. My temperature gauge needle is all the way up to the top all the time. Ignition on or off 1 Answer

I have a 1989 Camaro RS V6. On my way home from work yesterday I noticed that all my guages are floating the speedometer was bouncing around between 60 and 70 sporadically. The temperature gauge, oil gauge, rpm and gas gauge were all floating around when I slow down they all start coming back down? For just a second I smelt a very strong burning smell (electrical) that very quickly faded. The SES light has been on constant the whole time this is happening. Same thing was happening on the way to work this morning car is running and driving just fine. I guess today when I get home I can check the codes to see what codes I get as a starting point and work my way from there. I will also check the ground wires to see if maybe I am not getting good connection somewhere. Could it be my battery by chance? Maybe even a stripped wire somewhere?Any help would be greatly appreciated. Thanks! 4 Answers

I know the best advise would be taking it to a mechanic, but I do not have the funds for that they raped my wallet just a little over 2 months ago and now I am the only one working so there is just no...

What would make all 4 wheel brakes lock up at the same time in a 1991 Camaro RS? 1 Answer

1991 Camaro RS. I purchased as a "roller". After much work, I got the engine running again. Then when I drove it for about a 1/4 mile to test it, the brakes on all 4 wheels locked up. I had park...

Can anyone inform me why my Camaro takes off fine, but revs all the way when the pedal is to the floor, without much acceleration? 3 Answers

So not too long ago I started noticing my Camaro had been acting weird, it seems when I give it full throttle after being at around 50% throttle, the RPM's go all the way up and my speed catches up to...

I have 1992 Chevy Camaro RS,put all new break parts on the front axel, it still pulls hard right, and sometimes the pedal is not full . Help 2 Answers

I put all new parts on the frot end, calipers,rotors, and pads. Still is pulling Hard right, sometimes the pedal is full or goes down. Break Line Leak? Also when putting brass rings on the banjo bol...