Asked by Traye Aug 10, 2012 at 11:23 PM about the 2004 Dodge RAM 1500 ST 4WD
Question type: Maintenance & Repair
Head gasket job, crank kit as well. Check engine light was flashing. Diagnostic at parts store said misfire #3
cylinder. I've been told most likely coil. Is that most likely problem?
cjwalker18number33 answered 12 years ago
remove #3 plug and replace. reset code and see if the light comes on again. possibly cracked plug in repair process.
simple way to check, is to take cylinder #3s coil, and move it, and if the misfire follows its that coil.
Head gasket job, crank kit as well. Check engine light was flashing. Diagnostic at parts store said misfire #3 cylinder. I've been told most likely coil. Is that most likely problem?
2004 Dodge RAM 1500 ST 4WD
-
Maintenance & Repair
i have a 2007 dodge ram 1500 2wd. i was driving home last thursday morning and had my check enging light come on. I went and had the code read on it and it said that i had a misfire on cylinder #5. I ...
2007 Dodge RAM 1500
-
Maintenance & Repair
I have a coil pack failure and computer says it's number 3.
Dodge RAM 1500
-
Maintenance & Repair
I just bought a 99 dodge 1500 a few months ago and just had the tranny rebuilt and it still wont shift out of second gear..what else could it be..we replaced all the sensors and rebuilt the vavle bo...
1999 Dodge RAM 1500
-
Maintenance & Repair
I have 2006 dodge ram 4.7 liter and it has a code that is cylinder one misfire and I changed the plugs and coil and it still time rough and misfiring .....what else could it be??
2006 Dodge RAM 1500 SLT LB RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.