Boned_James_Boned answered 9 years ago
You can use jumper cables to either battery, but it will take a long time since there are two batteries. Once connected, let it sit for 15+ minutes before you turn the key. Even longer if it's cold where you are. The best batter to jump to is the one on the driver's side since it is the one that goes straight to the starter.
left my lights on
2001 Dodge RAM 2500 SLT Plus Quad Cab RWD
-
Maintenance & Repair
I purchased LED bulbs for the interior of my 2012 Dodge Ram 2500 crew cab. I need assistance in getting the map lights and rear light open to place the bulbs in the desired location. Can you give me s...
2010 Dodge RAM 2500 SLT Crew Cab 4WD
-
Maintenance & Repair
I have an 01 dodge 2500 v8 and she won't start. When I turn the key, I get only a single click, not rapid clicking and the engine won't turn over at all. Please help!
2001 Dodge RAM 2500
-
Maintenance & Repair
I replaced the crank sensor a few weeks ago due to hard starts intemit, Since then the truck has operated fine up till thia morning. It spins over fine but doesnt start. the rpm gauge moves when cr...
1999 Dodge RAM 2500
-
Maintenance & Repair
I had the trans rebuild, & it started not shifting into low gear at stops. It doesn't do it every time. I to it back. They replace the shift mod. & torque convertor. Took it apart & checked everything...
1999 Dodge RAM 2500 ST LB RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.