Your Answer:
Related Questions
-
My fuel pump n my buick park ave 2000 is not kickimg on and im wodering if the pump is bad or what else it could b not allowing it to run when i turn key on. that car was running n quit now wnt start 1 Answer
2000 Buick Park Avenue FWD
-
Maintenance & Repair
-
My 1989 Buick Park Ave 3800v6 has been running fine, on the way home the other week, my car stalled while driving, It started up fine then died again, after a few more attempts it started and ran fine. Drove a few hundred more miles, and it stalled again, as I was pulling over I was trying to give it gas, when it made a large boom sound, blew the exhaust apart at the clamp and caught the ground on fire underneath my car, we moved it from the fire, Just a little char from the burned up oil underneath, Nothing electrical burned, Car is still ok, besides the exhaust needing to be put back together.. What could cause the stalling, and choke and backfire? I cleaned the MAF and throttle body the night before this incident. 1 Answer
The car has stalled out twice, gasping for air, first time I shut off ignition and waited and got it started again. Second time I was pumping the fuel too many times and it back fired and caught the g...
1991 Buick Park Avenue Ultra FWD
-
Maintenance & Repair
-
i have a 96 buick park avenue. the clutch on the a/c is not engaging... is it the compressor thats bad or what? 1 Answer
my a/c started blowing hot air. when i looked under the hood i noticed the clutch wasn't engaging. was wondering if it was a bad a/c compressor or what?
1996 Buick Park Avenue FWD
-
Maintenance & Repair
-
this light poped up today my break fluid was low and i filled it up but my breaks didnt improve but i kept driving when i got home i checked my break fluid again and it was totally empty im not sure what to do never had a car before its a buck park avanue ultra 1999 2 Answers
this light poped up today my break fluid was low and i filled it up but my breaks didn't improve but i kept driving when i got home i checked my break fluid again and it was totally empty im not sur...
1999 Buick Park Avenue
-
Maintenance & Repair
-
When I turn the ignition key on to start my 2002 Buick Park Avenue 3800, the fuse blows for the ignition control module. Is this a common issue and where would I start troubleshooting on this problem? 6 Answers
The 10 amp fuse for the control module blow as soon as the key is turned to the run position.
2002 Buick Park Avenue FWD
-
Maintenance & Repair
Search Buick Park Avenue Questions
CarGurus Experts
-
#1jateen29Reputation3,210
-
#2Joseph KingReputation2,060
-
#3Jim CampbellReputation1,120
Find great deals from top-rated dealers
SearchRelated Models For Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.