2005 300
Drivers side headlight out. Replaced bulb still
nothing. Fuse is ok. Replaced FCM still nothing.
Maybe a bad ground? Bad wire?
mikeatpriestlake answered 7 years ago
get an electrical tester and see if you have power at the bulb plug. if not probe back a little farther on the wire and see if there is power there. if ther is, it is the connector.
When dealing with an 2005 Chrysler 300. Im having problems with an flashing thunder bolt symbol... I have the codes P2110 P2118 change old throttle body and replace it with new throttle body but st...
2005 Chrysler 300 Touring RWD
-
Maintenance & Repair
My 2005 Chrysler 300 cranks but won’t start code p0340 is popping up witch is for crank shall sensor I replaced that and cleaned throttle body n replaces spark plugs fuel pump in gadge please help ...
2005 Chrysler 300 Touring AWD
-
Maintenance & Repair
I have a 05 Chrysler 300 2.7l. I have a strong odor of gas coming from the right rear passenger door. I'm not consuming more gas and the car starts normal. The back right passenger floor is where ...
2005 Chrysler 300
-
Maintenance & Repair
Hi everyone... I have a 2005 Chrysler 300, and driving on the highway today, a "fluttering" sound began. It's coming from the front end somewhere. If I put the car in neutral and rev the car it d...
2005 Chrysler 300 RWD
-
Maintenance & Repair
My 2005 Chrysler 300 cuts off while driving without any warning. This has happened multiple times on a crowed interstate. I'm scared to drive it because there is no warning when it will happen aga...
2005 Chrysler 300 RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.