My 2000 Vic has a nasty rod knock and I found a replacement 2008 motor. Do I need a new wiring harness? What other problems could I run into when putting a new engine into an older car. 4.6 intercepto

My 2000 Vic has a nasty rod knock and I found a replacement 2008 motor. Do I need a new wiring harness? What other problems could I run into when putting a new engine into an older car. 4.6 intercepto 1 Answer

2001 ford crown Vic police edition p71 v8 engine 4.6 liter I have replaced the intake manifold, fuel pump, fuel filter, got a tune up, new thermostat, When I drive about 15 minutes or so my car lo 3 Answers

2001 ford crown Vic police edition p71 v8 engine 4.6 liter I have replaced the intake manifold, fuel pump, fuel filter, got a tune up, new thermostat, When I drive about 15 minutes or so my car ...

Do I need a new anti lock brake system 1 Answer

I work on a 1998 Ford Crown Victoria I changed the driver side CV axle rear after that the brakes start reacting every time I will press them I have confirmed that the CV axle was the right one I cl...

99 Crown Vic needs a control module/resistor which I was able to get with no problem; I also need a resistor which is on the engine side,of the firewall, and I have no diea what thispart is in order to replace it; a/c blower motor died 4 Answers

a/c working, though only on high, along with heat; compressor is fine, blower motor cut off; my mechanic tolde me to get a control module/resistor, as well as a resistorthat goes on the fire wall...

My 2006 ford crown vic will not go into drive right away in the morning or when i start it up after sitting a while.. Will take time to go into drive after accelerating 4 Answers

My 2006 ford crown vic will not go into drive right away in the morning or when i start it up after sitting a while.. Will take time to go into drive after accelerating ..