2000 crown Vic. will not start after I replaced intake manifold, it will roll over jut won't fire. I replaced the crank sensor, it's sending fuel. I tested the injectors with noid light all working.

Asked by Daltongc Jan 23, 2015 at 10:30 PM about the 2000 Ford Crown Victoria Police Interceptor

Question type: Maintenance & Repair

4,725

Josh answered 9 years ago

Check around your ignition and wiring make sure you didn't forget to plug in connectors. Make sure you have Spark as well. As well if you don't have a ground connected it could cause this same problem.

2 people found this helpful.

Mark helpful

1,360

luissixtyfive answered 9 years ago

thats a good answer from JRKPerformax

4 people found this helpful.

Mark helpful

15,925

Larry answered 9 years ago

Also, recheck all of your vacuum lines for one either on the wrong pipe or not connected.

Mark helpful

Your Answer:

2000 crown Vic. will not start after I replaced intake manifold, it will roll over jut won't fire. I replaced the crank sensor, it's sending fuel. I tested the injectors with noid light all working. 3 Answers

2000 Ford Crown Victoria Police Interceptor

-

Maintenance & Repair
2001 ford crown Vic police edition p71 v8 engine 4.6 liter I have replaced the intake manifold, fuel pump, fuel filter, got a tune up, new thermostat, When I drive about 15 minutes or so my car lo 3 Answers

2001 ford crown Vic police edition p71 v8 engine 4.6 liter I have replaced the intake manifold, fuel pump, fuel filter, got a tune up, new thermostat, When I drive about 15 minutes or so my car ...

2001 Ford Crown Victoria Police Interceptor

-

Maintenance & Repair
I have an 83 Ford LTD Crown Victoria. The fuel pump stays running when the key is on. Is this normal? The car will not start. There is pressure at the injectors and power at the injectors but no fuel comes out. If I dump gas on the carburetor, it will start but won't stay running. What do I do to fix this? 18 Answers

have an 83 Ford LTD Crown Victoria. The fuel pump stays running when the key is on. Is this normal? The car will not start. There is pressure at the injectors and power at the injectors but no f...

1983 Ford Crown Victoria

-

Maintenance & Repair
My 2006 ford crown vic will not go into drive right away in the morning or when i start it up after sitting a while.. Will take time to go into drive after accelerating 4 Answers

My 2006 ford crown vic will not go into drive right away in the morning or when i start it up after sitting a while.. Will take time to go into drive after accelerating ..

2006 Ford Crown Victoria Police Interceptor

-

Maintenance & Repair
I have a 2004 Ford Crown Victoria interceptor. I have replaced the crank positioning sensor, throttle positioning sensor and the cam sensor. I still do not get any power to the fuel injectors or the new fuel pump. Where do I go next? 1 Answer

The car first started stalling while driving, but would start right back up. Then it would only start after cooling down and finally it stalled at a stop sign and has not started since.

2004 Ford Crown Victoria Police Interceptor

-

Maintenance & Repair

Looking for a Used Crown Victoria in your area?

CarGurus has 5 nationwide Crown Victoria listings starting at $8,000.

Used Lincoln Town Car

7 listings starting at $9,995

Used Ford Explorer

78 Great Deals out of 2,097 listings starting at $2,999

Used Ford Mustang

61 Great Deals out of 1,274 listings starting at $4,995

Used Ford F-150

338 Great Deals out of 15,288 listings starting at $1,712

Used Chevrolet Impala

9 Great Deals out of 108 listings starting at $5,990

Used Ford Taurus

8 Great Deals out of 79 listings starting at $3,995

Used Chevrolet Camaro

16 Great Deals out of 314 listings starting at $10,500

Used Chevrolet Tahoe

22 Great Deals out of 922 listings starting at $11,900

Used Honda Accord

42 Great Deals out of 918 listings starting at $1,599

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

2000 crown Vic. will not start after I replaced intake manifold, it will roll over jut won't fire. I replaced the crank sensor, it's sending fuel. I tested the injectors with noid light all working.

3 Answers

Your Answer:

Looking for a Used Crown Victoria in your area?

Shortcuts

Search Ford Crown Victoria Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

2000 crown Vic. will not start after I replaced intake manifold, it will roll over jut won't fire. I replaced the crank sensor, it's sending fuel. I tested the injectors with noid light all working.

3 Answers

Your Answer:

Related Questions