That's an ignition timing problem. Or your valves are burnt.
I will replace my manifold intake ,it does have cracks and replace sensors as well as my manifold gaskets ,gas filter,ect. thanks a lot man you are awesome.
I put in new pugs and new coils packs.
2002 Ford Crown Victoria Police Interceptor
-
Maintenance & Repair
Will a 2003 ford crown Vic police intercepted transmission fit a 2002 ford crown Vic police intercepter
2002 Ford Crown Victoria Police Interceptor
-
Maintenance & Repair
my crown vic 2002 has new fuel filter,fuel pump x3,mass air sensor,new spark plugs,throttle body,altenator,battery and it will run fine in park but as soon as u put in gear starts missing bad wont go ...
2002 Ford Crown Victoria LX
-
Maintenance & Repair
My crown vic police interceptor was running just fine. I stopped at an atm, turned it off, got back in and attempted to turn it back on. it would turn over and make a low sputtering sound. I would t...
2001 Ford Crown Victoria Police Interceptor
-
Maintenance & Repair
i have a 06 crown vic PI and it started overheating a couple months ago. i changed the thermostat, flushed the cooling system, and checked the water pump (it was changed right before i bought it). t...
2006 Ford Crown Victoria Police Interceptor
-
Maintenance & Repair
CarGurus has 5 nationwide Crown Victoria listings starting at $8,000.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.