take the oil sending unit out and start for 2 seconds...did it make a mess?? and or remove vale cover start and check for oil flow at the valve rocker arm.
THAN KELLY.ALSO,I RESEARCHED AND FOUND IF YOU HAVE A NEEDLE OIL PRESSURE GAUGE,DISCONNECT WIRE,turn on key and if needle pegs out either way ,ITS THE OIL SENDING UNIT.THANKS AGAIN FOR YOUR HELP.
Is it timing chain?oil related electrical parts?1988 gmc jimmy 4x4 350 automatic?
1988 GMC Jimmy 2 Dr STD 4WD SUV
-
Maintenance & Repair
the truck ran fine the night before. it wouldnt start and when it did turn over it felt like it was sputtering. i got it started finally and drove down my street. it was about a mile into my drive w...
1999 GMC Jimmy 4 Dr SLE 4WD SUV
-
Maintenance & Repair
Yesterday I was driving my 1996 Jimmy with no problem to work and to do some errands. I parked it at my house and when I tried to start it this morning the clutch went right to the floor. This has ha...
1996 GMC Jimmy
-
Maintenance & Repair
when I adjust the temp. control knob I can not get any heat to come out of the vents. I can get cold air to come thru the vents but it will not change to hot air. I can hear the motor that it is try...
2001 GMC Jimmy
-
Maintenance & Repair
why do i need to takefuseout and back in to get my radio to work
1999 GMC Jimmy
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.