Ford Bantam Questions Maintenance & Repair

Dashboard Lights Bantam Bakkie 2006

Hi please can someone help. My ford bantam bakkie 2006 dashboard lights dont want to come on ?

Ford Bantam 1.3 Xl Rocam - I Need A Copy Of The Owner' Guide.

I was given a Bantam Bakkie 1.3 Rocam by my sons and it came without a owner' guide. can any one assist me?

Rocam Engine Water Bottle Pressurized

I have a 2006 Bantam rocam engine that overheats and the water bottle gets pressurized. Oil and water don't mix. Engine runs fine other than the overheating problem. What could be the solution.

I Have A 1.3 Ford Bantam Rocam

i droped my key and since then my car don't want to start, the light on the clock keeps flashing as if no key is inserted even when i try to crank .the remote works, pls help

Ford Bantam Rocam 1.3

My ford bantam shows that the cluster is not working I fitted a new battery bt now the gurges are not working, is there anything I could try before I replace the cluster? coz m worried I may buy a ...

I Drive My Ford Bantam 1.3 And It Was Raining A Lot And Come And Park It As...

I drive my ford bantam 1.3 and it was raining a lot and the following morning it jst cranking bt cnt start

No Spark

Hi i have a 1997 ford bantam 1.6i (B6 engine) i have no spark on the vehicle, i replaced the coil and two modules inside the distrebutor and send the distrebutor in to check it and the guy said it...

In Cab Temp Control,only Blows Hot Air.

If there is an airlock,in the cooling system,would this cause my in cab temp control,to only blow hot air,when switched to cold. I this airlock is the problem,as I have already changed the valve with...

Starting Failure

Ford bantam failing to start. Shows carlock on dash board

Please Help , A Person Worked On My 2007 Bantam And Now The Car Does Not Wh...

My 2007 bantam seems to be getting to much fuel , or to little . I have replaced the tps sensor , the car is fuel injection and this could mean any thing could be faulty .

Do I Need To Replace The Oil Pump On My Bantam

Ford Bantam 1.3 Rocam 2008, 170 000kms: I had a temporary drop in oil pressure followed by quite loud ticking coming from the cylinder head (I stopped the car immediately). I gave the car a little r...

2004 1300 Ford Bantam Xl

Hi..I recently replaced both front tyres.Supa Quick unable to align..car pulls to left..and I have a slight "hooking" on the steering when moving steering to the left on a few degrees.Have checked ...

Hi All M Having A Ford Bantam Roc Am 1.6 Engine, It Looses Power While Driv...

Tshepo

Fuse Box Center Rear Location

Must replace fuse 43* in central fuse box rear, cannot locate the fuse box. Where is its location please.

My Ford Bantum Has An Electrical Problem

hooter,rear left indicator light and hazards stopped working.

Where Is The Central Fuse Box Rear Side With Fuse 43* For The High And Low...

Slightly Mist

Hi im Cedrick need with rocam it's got a slight mist on engine any advise tnx regards Cedric

Hi My 2006 1.6i Rocam Also Shutters When It Heats Up Someone Told Me That I...

Bantam 1.3 Rocam Enjin.

Morning guys. My Bantom stated giving me probs 2 weeks ago. On pulling away and changing gears it first jerks 2 or 3 times then it goes.Even if its warmed up. What could be the problem

Hi,I Have A Ford Bantam Rocam .The Vechile Swings But Will Not Start.It Wil...