1996 Dodge Ram 1500 4x4 5.9
i've changed map,TP sensor,plugs,plug wires,Distriputor cap,rotary button, & the pick up .
My fuel pressure good .....
my plugs are soaked with fuel .. what would cause this & where is it located ?
Pease help .
What's it doing? Turning over but not starting?
Yes . And when I pull a spark plug it's soaked with fuel
Are you sure the plugs are firing? Was it doing the same thing before you replaced the parts?
Yes their is fire . I had a mis fire & autozone said it was my plugs . I changed them and it ran great for 4 days then this
http://autorepair.about.com/library/firing_orders/bl-fo-5900.htm -- double check the plug wire locations.
I've triple checked them .
Ok then dis regard my last post.
Ok thank you
Is your check engine light on? If so what are the codes?
No . I even have a friend that has a scanner & still can't get any info
Was you driving it and it just went dead or did you go to start it and it started doing this?
I drove it about 6 miles to Home Depot . When I can out this is how it was
Possibly egr valve stuck open. If it sticks open it can cause this sort of issue.
The scanner said it was good . But where is it located ? Thank you for your
From what I have found if yours has one it should be on the passenger side of the intake near firewall. I am finding mixed results tho. Some do have them and some don't. Dodge did some changes around that year model.
I'm not sure what you sayn . Can you send me a picture of it please
It should be right behind your last fuel injector on the passenger side of the intake. Right next to the firewall.
This one might be better. It's right at the point of the pin.
Ok Thank you I'll try it today .
Check this out too
Also check for any loose vacuum lines or electrical connections. That might have got bumped loose while you were working on it.
Okay . I checked all vacuum lines but I will again .. Thanks again for your help
Does the breather assembly have to be on before it will start ?
I don't see it anywhere . I must not have it . I have a 5.9 360
Crank position sensor might b bad
Catolack converter stopped up mine was it done The same thing
