My turn signal cam is broken I'm pretty sure. It won't hold when I turn left. Now this is on a 1970 ranchero, but I'm told the colum is a 1971. 1- I can't seem to locate one and 2- difficulty repacing

Asked by ddafternoons Jul 07, 2013 at 11:14 AM about the 1970 Ford Ranchero

Question type: Maintenance & Repair

Were do I find a cam? It's a 1971 steering colum I'm told, and if I do replace it how hard would it be?

DavidH25 answered 11 years ago

http://www.ebay.com/sch/Electric-Vehicle-Parts-/177701/i.html?_qfkw=1&_ssov=1&_fln=1&_from=R40&_nkw=ford+turn+signal&rt=nc

Mark helpful

DavidH25 answered 11 years ago

Oh I forgot the other part of your question. It's not really difficult but is time consuming.

Mark helpful

ddafternoons answered 11 years ago

I checked ebay, no go. I seem to find alot of other fords but mine is diffecult to find.

Mark helpful

Your Answer:

My turn signal cam is broken I'm pretty sure. It won't hold when I turn left. Now this is on a 1970 ranchero, but I'm told the colum is a 1971. 1- I can't seem to locate one and 2- difficulty repacing 3 Answers

Were do I find a cam? It's a 1971 steering colum I'm told, and if I do replace it how hard would it be?

1970 Ford Ranchero

-

Maintenance & Repair
1970 ranchero. Would upper ball joints cause a clunking sound when stopping? I did check tie rods,centerlink,idler, and lower ball joint. But I don't know how to check the upper joint. I had to stop yesterday,6-29-13, because it's just to darn hot out here. I bought this car for my son but now I realize I don't know what I'm doing. My wife informs me of that,lol. 2 Answers

Most of the front end parts are pretty tight. But I gave up on checking the upper ball joint because it just got 106 outside yesterday and I'm not sure how to check it for wear.

1970 Ford Ranchero

-

Maintenance & Repair
I have a 351 Cleveland engine that just wants to backfire through the carb. Checked timing and it appears to be accurate. The intake is a performer with a Holley carb, I think it's a 4160, but I just can't seem to make it sit, the intake, on the engine, without sealing properly. I've tried to seal the intake with black rtv at then ends of the intake won't seal. Replaced the intake gaskets with edlebrock gaskets and didn't use valley pan gasket, still can't get her to seal. It's leaking along the rear, right side intake matting service. I'm lost at what else to do. Help! 2 Answers

351c with a performer intake. Pop's on accel. Checked timing, it seems ok. I just can't get the intake to seal properly. No valley pan gasket,black rtv on the ends of the intake and using edlebrocks i...

1970 Ford Ranchero

-

Maintenance & Repair
rear main seal on a 351m in a 79 Ranchero is it split type or solid 4 Answers

Does my 79 Ford Ranchero Gt with 351m and fmx transmission have a split type or solid rear main seal in the motor

1979 Ford Ranchero

-

Maintenance & Repair
I have a 64 Ranchero. How can I tell which 6cyl I have in it, and which trany? The shift indicator has the Cruise O Matic emblem but it only appears to shift twice. 1 Answer

Curious to know if I have a 144 a 170 or a 200, but don't know how to tell. Shift indicator on steering columm shows P,R,N,Drive,Dot,L Cruise O Matic. Should be 3 speed, but only shifts twice. Evident...

1964 Ford Ranchero

-

Maintenance & Repair

Looking for a Used Ranchero in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

My turn signal cam is broken I'm pretty sure. It won't hold when I turn left. Now this is on a 1970 ranchero, but I'm told the colum is a 1971. 1- I can't seem to locate one and 2- difficulty repacing

3 Answers

Your Answer:

Looking for a Used Ranchero in your area?

Shortcuts

Search Ford Ranchero Questions

CarGurus Experts

Find great deals from top-rated dealers

My turn signal cam is broken I'm pretty sure. It won't hold when I turn left. Now this is on a 1970 ranchero, but I'm told the colum is a 1971. 1- I can't seem to locate one and 2- difficulty repacing

3 Answers

Your Answer:

Related Questions