how do you replace the valve cover gaskets
Asked by michaelfrazier Mar 08, 2013 at 03:49 PM about the 1998 Chrysler Cirrus
Question type: Maintenance & Repair
Asked by michaelfrazier Mar 08, 2013 at 03:49 PM about the 1998 Chrysler Cirrus
Question type: Maintenance & Repair
1998 Chrysler Cirrus
-
Maintenance & Repair
Where are the bleeder screws located? A picture would be great. Also, what tools are required to complete this? Will any specialty tools be necessary? Thanks in advance.
2000 Chrysler Cirrus 4 Dr LX Sedan
-
Maintenance & Repair
so in my 1995-2000 Chrysler cirrus the battery is in front of the left front tire. you have to take the tire off then this cover in order to get to the battery. what would happen if i drove without...
1998 Chrysler Cirrus
-
Maintenance & Repair
One morning my car just wouldn't start had it checked out and not the fuel pump the check engine light doesn't work and just seem to get any fuel coming through and no spark have did the starting fu...
Chrysler Cirrus
-
Maintenance & Repair
or is possible to disconnect the horn from the alarm? very loud. key fob even with new battery not lock or unlock the doors; too expensive to replace. car will shutdown after starting since alarm/ho...
1995 Chrysler Cirrus 4 Dr LX Sedan
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.