Popping noise

go back recheck wires make sure there back in proper firing order and tite at plugs and cap and cap is on properly

Did that already. Also checked under cap to make sure there wasn't any cracks or carbon cracks

Were the spark plugs put in tight, now do not over tight and strip thread but may need to see if loose or if something was left un-done or damaged.

They are in tight and I felt each wire pop on to the plug when installed but check them too!

Sounds like a plug wire is in the wrong position if that is all you did was plugs & wires and none of the other electrical connection were loosened or broken.

Maybe you need to pull plugs back out one at a time to see if gap closed.

Did you also lay the plugs side by side to compare them to be sure they were the same length ect.?

No I did not, I was never taught to do that! I still have my old ones so I will check that!! Thank you!

Your welcome, otherwise you will need to find the firing order and make sure its is still in correct order. (Its easy to make a mistake and get a plug wire on the wrong plug position).