Looking for a set of v8 vega headers

try car-part.com the largest network of salvagers in the US~...talk to one of the salvagers in your locality~

thought that one had an aluminum (easy-burnup) 4 cylinder engine...and were made into "sleepers" when the ole' 350 would bolt right in~

Summit Racing, Hedman Headers, Schofield Headers, JEGS or Sanderson Headers (which I have used on all my street rods). You want to use ceramic coated (to cut heat down) -- cast CHEVY small block, rear exit on the drivers side and center or rear exit on passenger side (if your running heater box). If you go with regular steel pipe header "shorts", make sure the exhaust flange to front crossmember (on the center dump manifold) has enough room to clear the curve of a mandrel bend pipe (or other type of bend depending on machine used). Going with rear dump manifolds eliminates this issue, but might bring up other issues such as steering column to exhaust manifold clearance on the driver side manifold. (Look under the Ford Ranger in my garage page at the '31 Ford Coupe I built back in 1991).

Again I'll direct you to eBay for another option to check. I have a number of saved searches which have items like this show up in them (yeah, in other posts I've suggested using quotes to get only what you're looking for) but when you're looking for H-Body stuff it's sometimes wise to keep your eBay searches wide. You can always delete the mail on the search or delete the search if it gets out of control with mails. But some sell parts from a project (sometimes a better way to try and recoup your money invested) that has fallen into that common pit of various reason for sitting unfinished. Worth a try. :)

I am currently building a 1977 Chevy Vega using a lot v8 monza motor mount sadles and I have checked everywhere for headers to fit with no luck.I ended up making a set of headers starting by using a old motor and trans for mocking up. I used a set of headers for a v8 s10 setup and I had to cut and reweld tubes. I have to say by doing it this way my motor and headers look like factory .I also recommend doing your steering shaft at this time you will need ujoints.