Drive shaft BALANCER???

15

Asked by Timkiley Jul 30, 2012 at 02:33 PM about the 1980 Ford Fairmont

Question type: Maintenance & Repair

OK! I just replaced u-joints and was doing the trans yoke and a round metal ring feel off as I was popping the last cap on the u/joint, It has a HT stamped on it! The drive shaft has the usual balance tabs and all is clean and neat. What is this and where oh where can I get that rubber ring that holds on the metal ring???? Do I even need this part??? !980 3.3 auto, thanks Tim Sr.

1 Answer

15

Great news here! Its a vibration dampener!!!!! Ihad to go to a truck shop that specializes in drive shafts, the counter guy knew right away what I described and told me it was ok to take the ring off as I would never be able to find the rubber ring that holds it on! Thanks for any one that looked here but problem solved!!

1 people found this helpful.

Your Answer:

CarGurus Experts

  • #1
    Dylan Higgins
    Reputation
    400
  • #2
    351_Stymeesmont
    Reputation
    210
  • #3
    MrBlueOval
    Reputation
    70
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.