Not starting

Asked by GuruCRNS7 Mar 04, 2019 at 05:44 AM about the 1995 Ford Bantam

Question type: Maintenance & Repair

Hi Guys, i have Ford Bantum 160i B6 and doesn't start just cranking. I replace
computer box, fuel pump but still not starting. if i pour some fuel to intake then it
start and addle for few minutes then cut off. seems like the injectors not
supplying fuel. what could be the course

1 Answer
16,945

Guru97FK8 answered 5 years ago

Check the ignition power supply to the injectors. The injectors are earthed in the cmputer box through pulses. Might be a good idea to that your vehicle to an Auto Electrician. To clear any fault codes, Ignition on acceseries, remove the Room light fuse and apply the brake for 20 second, this will clear any fault codes. Remember , with the Mazda system ever if you have rectified the fault, and the fault codes are still in the system, the system still assumes there is a fault, so codes MUST be cleared.

Mark helpful

Your Answer:

Related Questions

  • Not starting 1 Answer

    Hi Guys, i have Ford Bantum 160i B6 and doesn't start just cranking. I replace computer box, fuel pump but still not starting. if i pour some fuel to intake then it start and addle for few minutes t...

    1995 Ford Bantam

    -

    Maintenance & Repair

  • Ford rocam not starting 1 Answer

    Hi guys it's me again 1.3 rocam 2007 car was not cranking but batry oil and hand brake lights all on checked all fuses and a fuse below fuse box seems to have been an issue 10amp fuse I replaced a...

    Ford Bantam

    -

    Maintenance & Repair

  • Ford Bantum 1.3 have sparks and petrol but not starting 1 Answer

    Too much petrol but not starting

    Ford Bantam

    -

    Maintenance & Repair

  • ford bantam rocam not starting 2 Answers

    my bakie i have remove the engine to seal the leaks on oils but now when i replace it there was no spark fuel is not coming oil light and bettary light also not showing

    1995 Ford Bantam

    -

    Maintenance & Repair

  • For Bantam 1.3 2004 not starting 2 Answers

    Hi all I have a 2004 Ford Bantam 1.3 rocam that is not starting the lights on the dash come on but the fuel pump does not turn on and the starter motor doesn't turn over the light next to the clock ...

    Ford Bantam

    -

    Maintenance & Repair

Shortcuts

Search Ford Bantam Questions

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,630
  • #2
    MrRocket12
    Reputation
    1,150
  • #2
    Janus Welgemoed
    Reputation
    1,150
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.