Bantam 1.6 2010 no crank

10

Asked by Kerwin Jan 01, 2024 at 12:02 PM about the 1995 Ford Bantam

Question type: Maintenance & Repair

8 Answers

10

Hi i need help guys. 2010 bantam 1.6, no crank, no fuel pump prime. Checked fuses and relays ( all good )but still nothing. The immobilizer light comes on and goes off again after few seconds and stays off. New battery. Prior to this the vehicle drove good. Just got up one morning to that. Would appreciate your input.

16,945

Check the fuses and relays. This could be the main PCM fuse. Check the power hold relay. Its the small broiwn relay, the center to the right.

1 people found this helpful.
16,945

Please find below links for 2002 Bantam workshop Manuals and Wiring Diagrams. These diagrams can be down loaded onto you PC https://www.manualslib.com/manual/1106266/Ford-2002-Bantam.html#manual https://elektrotanya.com/ford_bantam_2002_wiring_diagrams.pdf/download.html

10

Thank you I will get into testing the relays tomorrow. The morning this happened I woke up to a dead battery which never happened before, I had the battery tested and charged( all good no dead cells). Since doing my checks of the electrical I noticed I only have one headlight working and the wipers stop midway( all electricals worked perfectly prior to that morning). Thanks again for your input Guru

16,945

If there is a Tracker, Disconnect the tracker as this will drain the battery. There is too much amperage draw coming from these. Check the amperage draw coming off the battery with the ignition OFF.

16,945

Check our Youtube clip on Not Cranking or starting : https://www.youtube.com/watch? v=hK7NJr9WALA

10

Hi Guru. When ignition is on the light will come on for a few seconds then go off or after trying to crank, the immobilizer light does not come back on it stays off. As I said the pats system doesn't come up with any codes. At this moment I just got to wait till I can afford an auto electrician, I'm currently unemployed. ( One thing that is weird that I picked up is when I have the ignition on, and put my lights on, only one light comes on. Prior to this problem all my electrics worked fine,and if I put my wipers on and turn them off midway they won't complete the cycle it will stop midway as I turn them off.

1 people found this helpful.
5

This is caused by the Relays , One controls the Crank Start and the other the Fuel Pump. I have been struggling with this for a long time. there are six Relays behind the fuse box. The first two are lights. the next two are starter and the fuel pump. You can swop any around , :Look at the Diagram given for the relays, I am also struggling to find this intermittent problem and have tried many things. Swapping relays works for a while . I have a long long list I have done to solve this. Nothing yet fixed permanently

Your Answer:

Bantam

Looking for a Used Bantam in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,630
  • #2
    MrRocket12
    Reputation
    1,150
  • #2
    Janus Welgemoed
    Reputation
    1,150
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.