Asked by Tucsonblaze42 Sep 18, 2014 at 12:15 PM about the 2005 GMC Yukon
Question type: Maintenance & Repair
As I drive my gauge will drop to zero then bounce back up to the proper levels. There is
no change in drive performance. Is this just a faulty sensor or switch and is fairly easy o
get to and change?
Tucsonblaze42 answered 10 years ago
I was able to switch out the oil pressure sender behind the engine and that has fixed oil pressure fluxuations.
As I drive my gauge will drop to zero then bounce back up to the proper levels. There is no change in drive performance. Is this just a faulty sensor or switch and is fairly easy o get to and change...
2005 GMC Yukon
-
Maintenance & Repair
Oil pressure gauge 06 denali 6.0 reads 80 all the time when engine running , with it off reads 0 gauge or sending unit or dirty screen ?
2006 GMC Yukon Denali AWD
-
Maintenance & Repair
I have a 2008 GMC YUkon that has been making banging noises from the front left of the car when driving. When I press on the break my oil pressure goes down to 0 but when I apply gas it goes back up...
2008 GMC Yukon SLT2 4WD
-
Maintenance & Repair
I Have A 07’ Yukon SLT. And I been Having battery drainage problems lately.. it will be working Fine than one minute I while get back in it to drive and it will be Dead! Get a jump, it comes back o...
2007 GMC Yukon SLT1 4WD
-
Maintenance & Repair
I replace a/c compressor twice thinking it was the compressor that wasn't working properly.
2004 GMC Yukon Denali AWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.