Rabbit_4410 answered 12 years ago
The engine mounts,and the bellhousing bolt-pattern are different,so,no....You"ll have to get a transmission,with the 429-460/351m400..bolt pattern..It can be done,,but ,not with your transmission..
from what i have been told. Sure the engine will bolt up to the 351m trans but it'll shake the tranny to pieces
1993 Ford Bronco
-
General
will there be a full size bronco like the1980
Ford Bronco
-
General
going to dealerships to shop for a toybox trailer-at 6300lbs GVWR and short wheelbase i realize my options are limited, i don't want a big trailer anyway-the only problem i have been running into is d...
1993 Ford Bronco XLT 4WD
-
General
I bought a transmission from someone that said it would work but I pulled the numbers of the side and it was a 86 will it work in my 88 bronco
1988 Ford Bronco Eddie Bauer 4WD
-
General
Replaced a steering column in a 95 bronco with one from a 93 bronco. It won't start. Swapped ignition key and switch. It turns, lights up dash(no odometer or oil gage though? ). Its not getting an...
Ford Bronco
-
General
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.