my mazda brake bulb has a black housing not on the replacement bulb. how do I take it off so as not to break the housing? Or do I have to buy a separate piece to connect the bulb to the socket?

Asked by Rick12086 May 12, 2015 at 05:17 PM about the 2005 Mazda Tribute

Question type: Maintenance & Repair

FordNut answered 9 years ago

http://www.mazdausa.com/MusaWeb/pdf/manuals/2005TributeOM.pdf

Mark helpful

FordNut answered 9 years ago

Page 41 Replacing brake/tail/turn/backup lamps bulbs The brake/tail/turn/backup lamp bulbs are located in the tail lamp assembly, one just below the other. Follow the same steps to replace either bulb: 1. Open the liftgate to expose the lamp assemblies. 2. Remove the two screws from the lamp assembly. 3. Carefully remove the lamp assembly by pulling it rearward. 4. Twist the bulb socket counterclockwise and remove from lamp assembly. 5. Pull the bulb straight out of the socket and push in the new bulb. 6. To complete installation, follow the removal procedure in revers order ..... Use Bulb 21/5W or if amber WY21W

1 people found this helpful.

Mark helpful

FordNut answered 9 years ago

Reading your question again I don't think I answered you. I was not paying attention. Let me look for what replacement bulb looks like

Mark helpful

FordNut answered 9 years ago

This is listed ad 2005 Mazda Tribute brake light bulb The signal/tail light is a more conventional 'globe' double filament bulb

1 people found this helpful.

Mark helpful

Your Answer:

my mazda brake bulb has a black housing not on the replacement bulb. how do I take it off so as not to break the housing? Or do I have to buy a separate piece to connect the bulb to the socket? 4 Answers

2005 Mazda Tribute

-

Maintenance & Repair
I tried to remove my factory radio from my 2002 Mazda tribute with a local removal wire and now the radio is not coming on nor can it be removed from its location. Can anyone advise me what to do next 5 Answers

I did not have access to a Din removal tool and so I used a coat hanger wire to remove the radio. The was not successful but the radio is not coming on anymore. I have to remove it to check the pro...

2002 Mazda Tribute LX V6

-

Maintenance & Repair
I replaced my ignition cylinder on my 2009 mazda tribute because i wasnt able to start the car without pushing on my ignition switch an turning car over at the same time.. do i have to have keys progr 2 Answers

Now car womt start do my new keys need to be peogrammed or could it be electrical if so what kind of electrical problem

2009 Mazda Tribute

-

Maintenance & Repair
My battery was dead so I replaced the battery. Now my radio does not power up, my door locks will not respond to the remote and my door and cargo dome lights have no power to them? 2 Answers

My battery was dead so I replaced the battery. Now my radio does not power up, my door locks will not respond to the remote and my door and cargo dome lights have no power to them? Is it a fuse or...

2004 Mazda Tribute LX V6

-

Maintenance & Repair
~~~~~~DO I need to replace the engine's computer after replacing the engine? ~~~~~~ 8 Answers

After replacing the engine from my 2001, 3.0L Tribute with an 2002, 3.0L Ford Taurus, pretty much the same engine, except that I had to do a few conversions by swapping a few parts. But after the inst...

2001 Mazda Tribute DX V6 4WD

-

Maintenance & Repair

Looking for a Used Tribute in your area?

CarGurus has 22 nationwide Tribute listings starting at $2,999.

Used Ford Escape

124 Great Deals out of 4,594 listings starting at $1,995

Used Toyota RAV4

108 Great Deals out of 2,083 listings starting at $3,888

Used Honda CR-V

103 Great Deals out of 3,896 listings starting at $1,795

Used Hyundai Santa Fe

58 Great Deals out of 1,604 listings starting at $3,950

Used Toyota Corolla

108 Great Deals out of 2,035 listings starting at $2,795

Used Mazda MAZDA3

74 Great Deals out of 1,510 listings starting at $2,495

Used Subaru Forester

28 Great Deals out of 1,075 listings starting at $2,695

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

my mazda brake bulb has a black housing not on the replacement bulb. how do I take it off so as not to break the housing? Or do I have to buy a separate piece to connect the bulb to the socket?

4 Answers

Your Answer:

Looking for a Used Tribute in your area?

Shortcuts

Search Mazda Tribute Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

my mazda brake bulb has a black housing not on the replacement bulb. how do I take it off so as not to break the housing? Or do I have to buy a separate piece to connect the bulb to the socket?

4 Answers

Your Answer:

Related Questions