After replacing timming belt car turns on but turns off when put it in drive

Asked by GuruX32TC Nov 26, 2018 at 05:09 PM about the 2000 Mitsubishi Mirage

Question type: Maintenance & Repair

After replacing the timming belt and everything
that was broke car turns on but when you put it in
drive or turn ac on it will turn off. The mechanich
had check everything and still do not work.

9,730

Mike answered 5 years ago

The cam timing can be a bitch if you didn't lock stuff in place. If it ran OK before you changed the belt it must be the belt.

Mark helpful

Your Answer:

After replacing timming belt car turns on but turns off when put it in drive 1 Answer

After replacing the timming belt and everything that was broke car turns on but when you put it in drive or turn ac on it will turn off. The mechanich had check everything and still do not work.

2000 Mitsubishi Mirage

-

Maintenance & Repair
Car turns off at red light 3 Answers

What does it mean when my car turns off at red light when my air is running? Before it turns off the car starts shaking a little.

2001 Mitsubishi Mirage ES

-

Maintenance & Repair
My car starts and idles fine but once it's in gear it surges and stalls, can some one help me? 3 Answers

So I just bought this car thinking it was just a sensor. Once I scanned the car it said it was transmission speed sensor A confirmed. So I ended up replacing the input and out put sensors and it s...

2000 Mitsubishi Mirage DE

-

Maintenance & Repair
Car stalls when out in great, but idles fine 1 Answer

Just had transmission serviced today, but drive my car a few hundred miles a day about 250 miles pay service and 4 hours driving this issue began. Never happened before this,. No smoke, or obviou...

2015 Mitsubishi Mirage

-

Maintenance & Repair
I have a 1996 Mitsubishi Mirage. The gas gauge appears to work properly until the gauge reaches below half a tank. Basically it shows there is less gas than what there is. When the gauge is completely on E it appears there is still 2-3 gallons in the tank. I say this because when I fill it up on E it takes about 10.5 gallons however I have a 13 gallon tank. What would cause this problem? Fuel level sensor or Fuel sending unit or something else? 1 Answer

I have a 1996 Mitsubishi Mirage. The gas gauge appears to work properly until the gauge reaches below half a tank. Basically it shows there is less gas than what there is. When the gauge is completely...

1996 Mitsubishi Mirage S Coupe

-

Maintenance & Repair

Used Toyota Yaris

10 Great Deals out of 202 listings starting at $4,770

Used Toyota Corolla

122 Great Deals out of 1,994 listings starting at $2,795

Used Toyota Camry

48 Great Deals out of 979 listings starting at $2,212

Used Kia Rio

9 Great Deals out of 171 listings starting at $3,795

Used Nissan Sentra

70 Great Deals out of 1,802 listings starting at $2,195

Used Hyundai Elantra

161 Great Deals out of 3,498 listings starting at $2,995

Used Honda Civic

176 Great Deals out of 3,690 listings starting at $1,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

After replacing timming belt car turns on but turns off when put it in drive

1 Answer

Your Answer:

Shortcuts

Search Mitsubishi Mirage Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

After replacing timming belt car turns on but turns off when put it in drive

1 Answer

Your Answer:

Related Questions