2000 Nissan Xterra 3.3L 6 cyl. code p0335 clears but returns after a couple of hours
1 Answer
brotherben answered 6 years ago
Check your crank position sensor, wiring, and connections.
1 people found this helpful.
brotherben answered 6 years ago
Check your crank position sensor, wiring, and connections.
2000 Nissan Xterra
-
Maintenance & Repair
Hi all, I have a 2000 Xterra XE base mod. When it's cold she starts rough she goes to about 1200 rpms then comes back down to around 1000rpms and runs great. This happens daily but once i get it sta...
2000 Nissan Xterra XE V6
-
Maintenance & Repair
I have a 2000 Nissan Xterra and it cuts off but I'm able to restart what is the problem
2000 Nissan Xterra SE 4WD
-
Maintenance & Repair
2000 nissan xterra 3.3L, I put too much engine oil (about 3 qts) and now it won't go over 15mph and the idle is very rough won't go over 2000 RPM. What type of damage did I cause? I Checked the timi...
2000 Nissan Xterra XE V6 4WD
-
Maintenance & Repair
My 04' 3.3L xterra will click but vehicle does not start. I replaced the starter and got the same result. Now, if the starter is out of the vehicle, it works fine. Install the starter in vehicle ...
2004 Nissan Xterra
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.