I have an 84 vet that will crank when you go to start it but will not fire up. The security light is blinking on the dash. Does this have anything to do with ti?

I have an 84 vet that will crank when you go to start it but will not fire up. The security light is blinking on the dash. Does this have anything to do with ti? 2 Answers

Stalling when hot... My 1967 427/400 Hp L68 Corvette stalls when I drive it for approx 15 to 20 minutes after a short time it will start back up and do it again. What is the problem? When it run is runs very strong. 6 Answers

My 1967 vet stalls after driving it for approx 15 minutes. If I wait a few minutes it starts back up only to repeat the problem. It has 3/2 barrel Holly carbs and they have been rebuilt. Can it b...

I have a 1969 Chevy Corvette. I have rebuilt or replaced almost every thing. I have not replaced the original A/C compressor but converted it to the new Eco friendly freon. I had it tested three times, had the cooler boxes cleaned out, fan replaced, yet I have trouble getting the car cool. I live in So. Cal. where it is a necessity of life to have the A/C work as good as when new from the factory. I put in heat/sound shielding under the floor mats, and had all components check for proper functioning. I was thinking of going to a serpentine belt system that would get the newest A/C compressor with the system. Has anyone done this or have any suggestions? 9 Answers

The A/C system does not leak, holds the proper pressure

I have a1987 corvette that wants to idle out when stopping at a lite or stop sign. Not all the time just sometimes 1 Answer

The vette will idle out then have to re-start. It does not do this all the time. It is a 4 speed

yes my lock is triped in the lock position on the 75 corvette new lock mechanism and the door panel is still atached so how do i get the door to open i have access the the two metal roday that i can pull on with a screw drriver is there another latch some were that im missing what are my opttions here 1 Answer

i have new lock and new latch that was installed on a 75 corvette when i put the pannel on i closed the door and now the door will not open so what are my options to get the door opened thank you mr...