driver door poer window motor.

Asked by northwestport Jun 02, 2015 at 02:24 PM about the 1965 Ford Thunderbird

Question type: Maintenance & Repair

I cannot remove the motor because the window is in the UP position due to a 12volt
problem at the console switchs. Th driver switch works but not for driver side and 12 volts
direct to door motor results in sparks only. I am apprehensive about removing the
regulator bolts for fear it will fall and jam. etc. Any suggestions? Thanks for considering
question, don

1,005

barneuma answered 9 years ago

Drill holes in inner door to get to bolts holding motor to regulator,then remove motor.

1 people found this helpful.

Mark helpful

northwestport answered 9 years ago

Thanks for the info, I will try this,holes idea.. I was thinking about cutting a square patch but inner door is not flat. Your Idea sound better.

Mark helpful