how to get to license plate bulbs

10

Asked by scoobysnacks1155 Nov 13, 2015 at 10:42 PM about the 2004 Buick Rendezvous

Question type: Maintenance & Repair

have not seen any exploded view or video on how to

5 Answers

The entire tail/backup lens assembly has to be removed from the trunk lid as shown in the drawing attached. There will most likely be some nut's or clip's on the assemblies mounting pins on the inside of the trunk lid. Disconnect the tail/back up lamp harness connector from the body wiring harness. Remove the tail/back up lamp assembly from the rear compartment lid. While supporting the tail/back up lamp assembly, unplug the tail/back up lamp harness grommet from the rear compartment lid and remove the tail/back up lamp from the vehicle. Remove the license plate lamp bulb from the lamp housing. Installation is the reverse of removal. From: http://www.fixya.com/cars/t11117279-change_license_plate_lamp_bulb_2004

9 people found this helpful.
10

Thank you but this a van with a rear hatch, along with wiper motor and the lights are at the top of plate

1 people found this helpful.
45,255

That model of van came with the lifetime license plate bulbs- Mr. Nut should have known that-

1 people found this helpful.

Your Answer:

Rendezvous

Looking for a Used Rendezvous in your area?

CarGurus has 2 nationwide Rendezvous listings starting at $6,995.

Postal Code:

CarGurus Experts

  • #1
    jimmypd65
    Reputation
    1,060
  • #2
    Bilhar
    Reputation
    980
  • #3
    tap517
    Reputation
    920
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.