Throttle postion sensor was bad replaced and now get read out that curcut input is to high truck is idleing low

Throttle postion sensor was bad replaced and now get read out that curcut input is to high truck is idleing low 1 Answer

I have a 2007 Dodge Ram 1500 SLT with the 4.7. The plugs for the 4.7 have a reach of 3/4". I believe my mechanic may have installed the plugs for the 5.7 hemi which are 1" in reach. My truck went into the shop perfectly fine and came out with the engine knocking. Is it possible that the 1/4" difference in length caused the pistons to strike the longer, incorrect plugs hence, that caused the knock? The shop admitted to me that the wrong plugs had been ordered. When asked if it was possible that they may have installed the incorrect ones, they told me that the thread size wasn't the same. Well, truth be told, it is the same size thread. Thanks for any input! 2 Answers

The plugs for the 4.7 have a reach of 3/4". I believe my mechanic may have installed the plugs for the 5.7 hemi which are 1" in reach. My truck went into the shop perfectly fine and came out with th...

My 94 dodge ram 1500, 5.2L, runs okay but began using lot of fuel. Had trouble codes 37, 32, and 51. Cleaned throttle body and checked for vaccum leaks or bad hoses. Code 32 gone away. Cleared code 51 which according to Haynes manual is not supposed to make the check engine light come on. Their is no code 37 in the Haynes manual for a gasoline engine on the 94 Ram. Their is for diesel engine. What is it, where is it at and how do I correct the problem. 51 I know is the O2 sensor. Truck runs great, shifts fine , but is still using more fuel than normal. Been reading about code 37 and transmissions, don't think my problem is there. Any help ? 5 Answers

Cannot get the Code 37 to clear, can disconnect the battery and the code 51 clears, The code 32 has not come back but 51 comes back. 37 does not go away. Engine light will not come on after starting...

My 1996 dodge ram 1500 will idle low enough to stall out and im not sure what it is 2 Answers

When I got my truck I got a complete tune up on it, replaced spark plugs, dist. cap, rotor, pcv valve, and new wiring. So I don't know what is causing my truck to stall out. When my truck is idling th...

my headlights for both high beam and low beam went out but fog lights, emergency lights, and tail lights all work good. what is the problem? 2 Answers

as I was driving in the dark, the whole headlights just went out and never came back on.