No oil pressure
Replaced wires plugs distributor cap an
rotor crank shaft sensor and battery won’t
start
Asked by Dodgeproblems Jun 18, 2018 at 05:16 PM about the 1998 Dodge RAM 1500
Question type: Maintenance & Repair
Replaced wires plugs distributor cap an
rotor crank shaft sensor and battery won’t
start
Oil pressure was dropping to zero then back up when stopped. Changed sending unit still happening. Changed oil, filter, and pump. Now have no oil pressure
1999 Dodge RAM 1500 Laramie SLT Club Cab LB RWD
-
Maintenance & Repair
Hey everyone I have never done this but I have run into a brick wall with my truck, I quite recently changed the fuel pump and then the other day as I was driving it started to stall out and then i...
2005 Dodge RAM 1500
-
Maintenance & Repair
I was driving down the highway everything was fine then suddenly my check gages light came on the oil gage went down to red line then the engine shut down now it will not start. There is oil in it.
2007 Dodge RAM 1500 SLT Quad Cab 4WD
-
Maintenance & Repair
i have a 2001 jeep with a 2001 5.2 v 8 in it. did a engine swap and i changed the op sensor and the oil and the oil filter. i took it on a drive and when i started it i had op on my 10 min drive the...
2001 Dodge RAM 1500
-
Maintenance & Repair
So i have an 01 dodge ram 1500 5.2L. I recently changed out my plenum (easier than I expected). After a couple of weeks, now when I first start my truck I have no oil pressure for about 30 seconds the...
2001 Dodge RAM 1500 ST LB RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.