2008 sebring 2.4l leaking oil from valve cover bolts and oil pressure sensor

Asked by marcelo22213 Jan 20, 2017 at 01:36 PM about the 2008 Chrysler Sebring

Question type: Maintenance & Repair

My 2008 chrysler sebring 2.4l is leaking oil from the
back of the engine block on the bolts of the valve cover
and oil pressure sensor only when the car is on does
anyone know what the problem could be ?

1 Answer

225,385

You should take it in to have the valve cover gaskets replaced. There are probably rubber grommets to seal the bolts in the gasket set. And the Oil Pressure Sending Unit needs to be replace. They do and can leak a lot of oil. It's just old. Common problems here.

1 people found this helpful.
Best Answer Mark helpful

Your Answer:

CarGurus Experts

  • #1
    Sparky222
    Reputation
    4,990
  • #2
    ces13
    Reputation
    2,870
  • #3
    C Daigle
    Reputation
    2,770
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Chrysler Crossfire
12 listings starting at $7,990
Used Ford Mustang
33 Great Deals out of 1,822 listings starting at $5,999
Used Ford F-150
246 Great Deals out of 13,976 listings starting at $1,795
Used Chevrolet Equinox
94 Great Deals out of 3,271 listings starting at $2,490
Used Chevrolet Impala
11 Great Deals out of 113 listings starting at $3,999
Used Chevrolet Malibu
36 Great Deals out of 837 listings starting at $1,499
Used Ford Taurus
86 listings starting at $4,800
Used Toyota Camry
47 Great Deals out of 936 listings starting at $2,995
Used Jeep Wrangler
101 Great Deals out of 4,641 listings starting at $6,995
Used Land Rover Range Rover
10 Great Deals out of 383 listings starting at $12,988
Used Pontiac G6
6 listings

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.