Release linkage for boot latch

Asked by 1957bulldog Sep 14, 2016 at 08:55 PM about the 1987 Cadillac Allante

Question type: Maintenance & Repair

When both release cables are broken is there another way to release boot without cutting boot off?
Thank You

535

D_Yaros answered 8 years ago

Find the end of the now broken cable attached to the release mechanism and pull hard on it!

Mark helpful

Your Answer:

Release linkage for boot latch 1 Answer

When both release cables are broken is there another way to release boot without cutting boot off? Thank You

1987 Cadillac Allante

-

Maintenance & Repair
I need a replacement boot for 92 Allante convertible; any ideas on where I can find one? 5 Answers

My convertible boot for 92 Allante (maroon). My current boot has been damaged in 3 separate areas from previous owner. Any input on where to locate.

1992 Cadillac Allante FWD

-

Maintenance & Repair
where is fuse located for 1993 cadillac allante cruise control 2 Answers

trying to locate fuse for repairing cruise control in 1993 Cadillac allante

Cadillac Allante

-

Maintenance & Repair
My 1990 Alantee acts like it is not getting gas. I can shoot starting fluid in the air filter and the car runs fine until the fluid burns out. I checked the fuses in the center console and they are OK. This happened after the security system went off as a result of me changing a dead battery. I was wondering if there are 2 possibilities preventing the car from running. 1 â Did the factory security system cause my fuel pump to deactivate? And do I need to reset it??? Or 2 â could I have blown a fuse someplace when I changed batteries? I suspect the fuel pump has no power because when I turn the key, I can not hear the pump. Thanks for your comment on this question. 10 Answers

My 1990 Alantee acts like it is not getting gas. I can shoot starting fluid in the air filter and the car runs fine until the fluid burns out. I checked the fuses in the center console and they are ...

1990 Cadillac Allante FWD

-

Maintenance & Repair
I am installing a HHO GENERATOR on my 1989 Cadillac Allante. The instructions state to use the fuel pump relay as a power switch. What is another option for a switch? 1 Answer

The fuel pump relay only operates when I have rpm, for safety purposes, and the HHO GENERATOR needs to act in the same way. The fuel pump relay location is in a difficult place to get to. What is an...

Cadillac Allante

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.