where is the low side service valve (quick disconnect) fitting located on a 2008 ford focus to check and add freon
Asked by stephgas Jun 02, 2013 at 06:31 PM about the 2008 Ford Focus
Question type: Maintenance & Repair
the trim option does not include a zx4 sedan which is my vehicle. also there is a quick disconnect port on the drivers side to the right end and slghtly foorward in the general location of the radiator and condenser coil that is facing straight up but a/c service q-disc. won,t fit. can anyone tell what it,s for ?????????????
5 Answers
Does the port you are trying to connect it to have a green cap? The high-pressure service gauge port valve is located on a vertical extension off the receiver/drier tank. The valve can be accessed through an access hole in the upper radiator air deflector to the right of the LH headlamp. The low-pressure service gauge port valve is located on the A/C compressor suction line near the RH shock tower.
The service port on the left or drivers side which is facing up or verticle and is accessed through a hole in upper radiator cover (i.e.air deflector) is larger than a suction or lowside service port. Is a highside service port larger than the suction side port?????. The suction side port that u say is located bt the left or passenger side shock tower is the lowside pressure switch. So I guess I,am back to where I started from.
Are you putting the right fitting on the right one
2008 Ford Focus SE: The A/C rechange fitting is under the hood on the passenger side. It jhas a black cap & is located 2 or 3 inches from the yellow cap on the windshield washer reservoir.
does a 2001 ford focus se have a low pressure switch
