I am thinking of buying a 1961 ford falcon. Its mechanically sound but the front passenger side has a hole in floor and some rust. Is this costly and is it fairly easy to fix?

I am thinking of buying a 1961 ford falcon. Its mechanically sound but the front passenger side has a hole in floor and some rust. Is this costly and is it fairly easy to fix? 2 Answers

My 2008 Ford Escape AWD floor matts keep getting soaked. I thought I had fixed it by making sure the sunroof was closed properly, but it has continued. I have tried to figure out where this is coming from and finally after drying them out again I laid under the the vehicle and both on the drivers side in the middle of the front floor area and the passanger side there is a small hole about the size of a dine right in the middle. That would account for the water coming in after rain storms and such, but why would these two holes be there? Was there a drain area there with plugs and they are missing? Can I have a piece of metal welded over them? Don't know why they would be there. Doesn't seem to be a rust issue as it is frim all around these small holes. 7 Answers

Water leak on floors from underneath. There is a small hole size of a dime on both drivers side and passanger side underneath floor matts right in the middle of each. Can I have this repaired with a...

MMy dad has a 1992 Ford straight 6 flare side and I know there is a safety switch on the clutch and he has to slam the clutch almost through the floor to get the truck started. How can he fix this and can it be adjusted. One friend told me and I saw it online another place that you can dissasemble it and wire it back together bypassing the safety switch. I need some advice on the best and or cheapest way to fix it. Thanks 5 Answers

MMy dad has a 1992 Ford straight 6 flare side and I know there is a safety switch on the clutch and he has to slam the clutch almost through the floor to get the truck started. How can he fix this ...

I have a 2000 Ford Contour. I ran a few errands yesterday with no issues. I did not hear any changes in how the car starts or how long it takes. I went out to my car today and it does not turn over. All lights/electricity is on, it makes the sound like its trying to turn on, but will not turn. I bought a new battery hoping that was part of it. That is not the issue, left it plugged in over night and did not drain, so it does not appear to be alternator (which was recently replaced) what else could it be? (I am thinking of the starter, but could it be anything else?) 3 Answers

I ran a few errands yesterday with no issues. I did not hear any changes in how the car starts or how long it takes. I went out to my car today and it does not turn over. All lights/electricity is o...

i am having a problem with my 1996 ford explorer.when i put the transmission into gear and the car starts to move it makes a loud shaking and clanking noise in the left front end.people are telling me its the hub and knuckle but when i took the tire off i pushed the rotor around and it sounds like it is coming from the shaft after the knuckle can you tell me where to look 1 Answer

i have a 1996 ford explorer and i am having a problem in the front end.when i put the transmission into gear and start to drive there is a loud noise coming from the left front end.if i stop it goes a...