crank no start, no spark, fuel pressure good
60

Asked by Tech12345 Sep 04, 2015 at 12:51 PM about the Chrysler 300M

Question type: Maintenance & Repair

crank no start, fuel pressure 60 psi, no spark.
I have power to the ignition coils, not getting a ground signal to coils from
PCM. No codes
asd relay is energizing properly, cam and crank sync look great through
scanner.
Is there a known area of chaffed wires, or do I have a possible issue with
PCM????

7 Answers

FordNut answered 9 years ago

Thinking SKIM, the Sentry Key Immobilizer. If recognized, it sends a signal to the BCM over the PCI communication bus, which then tells the PCM that it's OK to start. So an anti-theft device issue. It will crank, as you describe, but not fire

11 people found this helpful.
Mark helpful
60

Tech12345 answered 9 years ago

2003 3.5 liter , no BCM codes either , and my Snap On Solus Pro shows that the SKI is not in theft mode

6 people found this helpful.
Mark helpful
70

GuruCKGS answered 7 years ago

Well have a 2000 m only have spark on one coil and replaced can sensor and crankshaft sensor

7 people found this helpful.
Mark helpful
140

Guru5T3BK answered 6 years ago

Car turns over spray staterfluid in breather no fire at all what's wrong.

14 people found this helpful.
Mark helpful
40

GuruSHCCX answered 5 years ago

I have the same issue with my 08 300 2.7L .... did you figure it out yet?

4 people found this helpful.
Mark helpful

Your Answer:

Related Questions

  • crank no start, no spark, fuel pressure good 7 Answers

    crank no start, fuel pressure 60 psi, no spark. I have power to the ignition coils, not getting a ground signal to coils from PCM. No codes asd relay is energizing properly, cam and crank sync look g...

    Chrysler 300M

    -

    Maintenance & Repair

  • Why no start or crank after ECM change? 1 Answer

    After replacing a bad ECM now the car will not crank nor start. Thought it was low battery tried to charge and gage on charging goes crazy. Please advise

    Chrysler 300M

    -

    Maintenance & Repair

  • Why no Spark 1 Answer

    Chrysler 300m special 2002 3,5 died while driving. Lights still worked and never went off. Not getting any spark from any plug. Changed cam sensor and crankshaft sensor which came up in codes, st...

    2002 Chrysler 300M Special FWD

    -

    Maintenance & Repair

  • 2002 chrysler 300m has no spark on 4 cylinders i need help 2 Answers

    its only has spark on cylinder 2 and 3 and the others dont.

    2002 Chrysler 300M

    -

    Maintenance & Repair

  • no signal or hazard signals replace relay and bulbs nothing 1 Answer

    no signals replace bulb and relay nothing no hazard signals

    2002 Chrysler 300M

    -

    Maintenance & Repair

300M

Looking for a Used 300M in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

Shortcuts

Search Chrysler 300M Questions

CarGurus Experts

  • #1
    aztec626bf
    Reputation
    710
  • #2
    Chaddyboy
    Reputation
    660
  • #3
    meanoldmoe
    Reputation
    610
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Chrysler 300
34 Great Deals out of 516 listings starting at $4,999
Used Dodge Charger
38 Great Deals out of 645 listings starting at $4,888
Used Chrysler 200
19 Great Deals out of 265 listings starting at $1,995
Used Dodge Challenger
33 Great Deals out of 475 listings starting at $7,999
Used Chevrolet Camaro
16 Great Deals out of 307 listings starting at $10,500
Used Chevrolet Silverado 1500
202 Great Deals out of 5,975 listings starting at $2,975

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.