Ford rocam Bad starting

Asked by Guru9BBQK4 Jun 15, 2021 at 06:37 AM about the Ford Bantam

Question type: Maintenance & Repair

Ford rocam 2009 not starting when cranking but starts when push started.

Any ide ?

2 Answers

16,945

I had a few of these. The starter solenoid wire is running in the same channel as the crank angle sensor. When the starter solenoid is energized this induces a higher voltage into the crank angle sensor wiring. Move this solenoid wire out of the crank angle sensor wiring channel. Check the condition of the main starter cable from the battery to the starter. Clean the terminals and the amperage draw on this cable. Check the earth cable from the battery negative to the body and fit an extra earth cable from the battery Neg terminal to the gearbox.

1 people found this helpful.

Your Answer:

Bantam

Looking for a Used Bantam in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,630
  • #2
    MrRocket12
    Reputation
    1,150
  • #2
    Janus Welgemoed
    Reputation
    1,150
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.