how do I lubricate propeller shaft on 07 Tundre
1 Answer
migration_judge_roy answered 11 years ago
All of this is either "built in" to the oil chamber or accomplished with sintered bronze bearing inserts~
1 people found this helpful.
migration_judge_roy answered 11 years ago
All of this is either "built in" to the oil chamber or accomplished with sintered bronze bearing inserts~
Toyota Tundra
-
Maintenance & Repair
HAD CODES PULLED THREE TIMES AND IT CONTINUES TO CALL FOR A NEW CAMSHAFT POSITION SENSOR. WHERE IS LOCATION OF THIS SENSOR AND HOW LABOR INTENSIVE IS IT TO REPLACE.
2001 Toyota Tundra V8 SR5 4 Door Extended Cab 4WD
-
Maintenance & Repair
2010 Toyota Tundra, 5.7 v8. I have recorded a video of my drive shaft today. It starts vibrating/pulsing around 50mph and stops at 57mph. What do you think? Do I need a new drive shaft??? Most pulsing...
2010 Toyota Tundra Limited Double Cab 5.7L
-
Maintenance & Repair
it is throwing 2 codes P2241 indicating O2 sensor heater circuit is open or shorted causing the circuit voltage to be low. This will cause the fuel feedback control to not work and the ECM to put t...
2007 Toyota Tundra SR5 5.7L Double Cab 4WD
-
Maintenance & Repair
check engin light is on
2000 Toyota Tundra V8 SR5 4 Door Extended Cab RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.