My guess is the hydraulic operating pressures drop when the fluid is warm and thin.
So could a fluid and filter change fix this and do you have to drop the tranny to do it? ('02 ES)
I would try a fluid change to see if it helps but if it does not you may be looking at a rebuild.
Does the filter change require dropping the tranny?
Fluid is full, never slips cold.
Mitsubishi Lancer
-
Maintenance & Repair
when ever i turn on my AC the RPM goes down and cause the AC to not run properly and the car to idle poorly
2002 Mitsubishi Lancer ES
-
Maintenance & Repair
Hi there I have a Mitsubishi Lancer Ralliart 2006 and my Remotes just stopped workings (Batteries are good). No remote start, no lock-unlock, no alarm. When I start the car the only button that show ...
2006 Mitsubishi Lancer Ralliart
-
Maintenance & Repair
When stopping at a red light my car shakes a little and turns off. If i step on the gas a bit while stopped it stops shaking at that light and does it again at the next. My car is about to hit 100,000...
2008 Mitsubishi Lancer ES
-
Maintenance & Repair
I have a 2012 Mitsubishi Lancer SE AWD. The car randomly won't start, sometimes it does, and sometimes it doesn't. When it doesn't start I have to get a boost and then it runs fine. It makes no soun...
2012 Mitsubishi Lancer SE FWD
-
Maintenance & Repair
CarGurus has 157 nationwide Lancer listings starting at $2,350.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.