I previously asked a question about a code P0038. I got an answered and
Thank You very much. My question is, where the wiring harness is for the
B1S2 that was replaced, if a wire is not connecting into the black connector all
the way in on the harness, not the wiring on the sensor itself, would that set
the code off P0038?
But would the Code P0038 come up on the Diagnostic Code Reader or the Code for a Bad Oxygen Sensor? That's where I'm lost.
I previously asked a question about a code P0038. I got an answered and Thank You very much. My question is, where the wiring harness is for the B1S2 that was replaced, if a wire is not connecting ...
Jeep Liberty
-
Maintenance & Repair
I have a 2002 Jeep Liberty with a harness that needs to be replaced for the positive in the negative is negative and to the alternator or not tell them either but the starter I just need to know i...
2002 Jeep Liberty Limited 4WD
-
Maintenance & Repair
Jeep liberty 04 will not start after fixing timing belt, replacing crankshaft position sensor, replacing one ignition coil, and replacing spark plugs. Please does anyone have any ideas?
2004 Jeep Liberty Sport 4WD
-
Maintenance & Repair
I have a bad crankshaft sensor, the engine wasn't start so I replaced the sensor and after 10 min the new sensor fail so I replaced again and after 10 min that sensor fail, so I don't know if is a...
2002 Jeep Liberty Sport
-
Maintenance & Repair
liberty died while driving, tach jumped a few times even though motor was not running. restarted after a few minutes, ran for another few miles and did same thing again. code came up as p0340, camshaf...
2002 Jeep Liberty Renegade 4WD
-
Maintenance & Repair
CarGurus has 29 nationwide Liberty listings starting at $2,995.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.