when I go to start my 2005 Chevy work van it just spins freely I change the starter and it still just spins
when I had the starter off and was putting
the new one on I could take the flywheel
and spend it with my fingers is that a
problem
josenenriquez answered 9 years ago
flexplate bolts came off and that's why you could the flexplate..oh by the way a flywheel is use on a clutch and the automatic transmissions have a flexplate
when I had the starter off and was putting the new one on I could take the flywheel and spend it with my fingers is that a problem
Chevrolet Chevy Van
-
Maintenance & Repair
I just replaced all 6 tires on it. My issue is the entire thing vilently shakes when I get to 15mph. once it drives for 2 miles it stops and then starts around 35 mph. smooths out kinda around 45. i...
1982 Chevrolet Chevy Van G30 Extended RWD
-
Maintenance & Repair
See the question
1994 Chevrolet Chevy Van
-
Maintenance & Repair
The blower will only blow on High and will stop working after the car is turned off for a while, but if I shut off engine and turn it back on to ACC with all diagnostic lights on immediately after shu...
1998 Chevrolet Chevy Van G1500 RWD
-
Maintenance & Repair
My brother & I own a 1990 Chevy conversion van We get it jump started. It runs.The next day the battery is dead.We take it to get check the battery is fine, It gets charged 4 HRS. Runs OK. Next day...
1990 Chevrolet Chevy Van G20 RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.