1993 Silverado
I have a 93 that the heater/ac control linkage came off the vent door. Does anyone know the procedure (other than just put it on and hope for the best) for re-installing the linkage?
Asked by perplexed1959 Feb 20, 2013 at 02:17 PM about the Chevrolet Silverado 1500
Question type: Maintenance & Repair
I have a 93 that the heater/ac control linkage came off the vent door. Does anyone know the procedure (other than just put it on and hope for the best) for re-installing the linkage?
if alignement is as factory ,should stay put, for sure make a loop of thin wire as a lock
perplexed1959 answered 11 years ago
i CAN'T TELL WHAT POSITION THE LINKAGE IS IN COMPARED TO THE VENT DOOR...ANYONE KNOW THE PROCEDURE FOR THIS?
I have a 93 that the heater/ac control linkage came off the vent door. Does anyone know the procedure (other than just put it on and hope for the best) for re-installing the linkage?
Chevrolet Silverado 1500
-
Maintenance & Repair
the fuel pump will run but truck wont start. 1993 chev Silverado,
Chevrolet Silverado 1500
-
Maintenance & Repair
What engine is in my 1993 chevy silverado 1500
1999 Chevrolet Silverado 1500 LS Extended Cab RWD
-
General
1993 Silverado 350 motor . Truck starts and idles then it dies it will start right back up but will not stay running, any suggestions?
1993 Chevrolet C/K 1500 Silverado Extended Cab 4WD
-
Maintenance & Repair
I have a 08 silverado crew cab 5.3 v-8 ..put 93 octane gas in it and engine light came on,can any one tell me what this might be??
2008 Chevrolet Silverado 1500 LS Crew Cab 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.