Start by checking your battery, take the connectors of and clean the with for example wire brush or sandpaper both on the wire connection and on the
battery, it is also good to apply Vaseline or grease over the connector´s after you put the back on the battery to seal them. If you can open the
battery check the water level it is supposed to flow over the metal plates in there. If this does not fix your idle in about 24 to 36 hours, which it could
take to fully recharge the battery, have your batter load tested and check if the alternator is producing over 14 volts as it should.
For code 1494 here is what it says on the Chrysler code side:
P1494 (M) Leak Detection Pump Sw or Mechanical Fault Incorrect input state detected for the Leak Detection Pump (LDP) pressure switch.
2 people found this helpful.