Auto_Centric answered 8 years ago
Easy, make sure you have the carburetor sized correctly 600 CFM is plenty! Pay if you need to have it tuned and jetted properly after you install it. Don't be like so many who skip this and never gain the full befits. Regards
Thanks...is there a manifold switch needed...
Dodge Power Wagon
-
Car Customization
I have a 1977 dodge D100 I’m doing a rebuild on and I’m wanting to replace the bench seat with the 60/40 seats out of a mid 90’s model will they fit and what all will I need to do to make them go i...
1977 Dodge Power Wagon
-
Car Customization
I'm trying to find a tranny that will fit in my w200 pick up. I did a motor swap from 318 to a 440.it's a full time 4wheel drive
1977 Dodge Power Wagon
-
Car Customization
The 77 d150 is perfect in all ways other than it's 2wd. It's got the slant 6 engine and a 4 speed tranny that's not original. I could buy a rolling w200 that has everything except the engine but I'd...
1977 Dodge Power Wagon 150
-
Car Customization
I have a 350tbi engine that I would like to drop in my 77 dodge truck.. where can I find an adaptor plate to mount w the stock transmission?
1977 Dodge Power Wagon 150
-
Car Customization
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.