What is a typical fee to have the radiator support arm sanded and painted.

20

Asked by Ga Dec 10, 2015 at 08:47 PM about the Pontiac Fiero

Question type: Maintenance & Repair

Although it wasn't pointed out, I have been told that the radiator support arm
needs to be sanded and painted in order to preserve it. Please advise what
the average cost of that job would be thank you.
GAW

F_O_R answered 8 years ago

Why not pull the radiator and sand and paint it yourself? Use a good primer and some Rustoleum paint.

2 people found this helpful.

Mark helpful

189,455

Paul answered 8 years ago

If you dont want to do it, I would say about 200.00 depending what type of paint you want to paint it with...

4 people found this helpful.

Best Answer Mark helpful

Your Answer:

What is a typical fee to have the radiator support arm sanded and painted. 2 Answers

Although it wasn't pointed out, I have been told that the radiator support arm needs to be sanded and painted in order to preserve it. Please advise what the average cost of that job would be thank ...

Pontiac Fiero

-

Maintenance & Repair
Where is the radiator support arm? Mine is rusting and I intend to shape it up. 2 Answers

My radiator support arm is reportedly rusting and needs a clean up. Please advise where I can find it, and is it a problem job. Thanks GAW

1985 Pontiac Fiero Base

-

Maintenance & Repair
I have a 1986 Fiero 4 speed manual and I have replaced the clutch and slave cylinder and it still wont shift what could the issue be? 1 Answer

When you turn the car on and go to put it in reverse all it wants to do is grind the gears and when you try to put it in the other gears it stops and don't go shift. What could be going on?

1986 Pontiac Fiero SE

-

Maintenance & Repair
Is there a way to siphon out the gas vs taking off the tank? 3 Answers

I've got a tank full of bad gas and would rather siphon it out but cant seem to get hose in far enough to get to the gas. The only option I have left is to take off the tank and drain.

1987 Pontiac Fiero GT

-

Maintenance & Repair
im having a problem, i took apart the caberater on my 1988 fiero and cant find the correct places to put the vaccum lines, i know where they go i just dont know which line to which, it ran fine before i took it apart, now i think that the lines are switched around, can you tell me what goes where or shoow me a site where i can find out, like a car manuel site? 2 Answers

i had to take the valve cover off and that reguired that i take like a senser that is covering one of the bolts, in the process i found that two of my vaccum lines had broken so i took the carb off be...

1988 Pontiac Fiero

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.