Help please! I have a 1994 winnebago warrior with a Chevy 454 tbi. It doesn't want to idle and dies when you put it in gear.. any suggestions? . .
It seems to have a long crank time before starting sometimes it starts and dies.
Sometimes it starts and surges before dieing and other times it starts and seams to idle
fine. But it always stalls when put into gear unless you have your foot on the accelerator.
If you try to Rev it when it doesn't want to idle it will stumble then pick up but will only
come up to about 3/4 of its power band and act like it has a Rev limiter. It has done this
since I acquired it. I kinda thought fuel pressure but after sitting last winter the fuel
pump locked up. So it is now new along with the fuel filter. .
19 Answers
Clean the throttle body and IAC,sound like it may not be getting enuff air to the fuel system.
KubotaJohn answered 9 years ago
Yeah I tried that earlier today. New diaphragm and spring in the regulator too.. thanks for the reply
KubotaJohn answered 9 years ago
When it does decide to run good it runs real good. You can jump on it and it will come back to idle. Until it is put into gear, then it will die. . But when it is running good. It is as if someone out of the blue flips a switch and it will go back to acting like a pig.. it throws oddball codes 22, 42, 36 are the codes I have seen so far. It is getting pretty frustrating. .
KubotaJohn answered 9 years ago
No, I have not done that. . Do you think that the sensor braking down may cause this problem? Every cps problem I have encountered it has either been it works or it doesn't.
KubotaJohn answered 9 years ago
I just finished changing the ignition control module with No change in operation.
Crank sensor are funny win they are bad,will work sometimes,then not other,s,sounds familuar?
KubotaJohn answered 9 years ago
I am leaning more and more towards thinking it is the ecm..
Could be,but i think if you have not replaced the crank sensor,that would be a good thing to do,and if that is not the issue,the i agree with you,the ECM.
KubotaJohn answered 9 years ago
Alright man I will try that tomorrow and repost.. Thanks for talking to me.
HI...READ UP ON THIS....http://www.chevytalk.org/fusionbb/showtopic.php?tid/202722/
KubotaJohn answered 9 years ago
Lol, you could have just told me to throw a carb on it and dummy load everything. . I had thought about it and as a last resort it's definitely an option. Thanks for the reading, there is some helpful info
KubotaJohn answered 9 years ago
...so there is no ckp sensor it is obd1 gm.. closest to a ckp it has is a pick up coil and that is more of a cmp if anything. . Should have caught this last night but I was tired. ..
KubotaJohn answered 9 years ago
Just put a higher pressure fuel pump in and she runs better than ever. .thanks Delphi for the junk pump. .
