Autometer Gauges Needles Jump with turn Signal
40

Asked by JohnnysBelair May 19, 2011 at 04:30 PM

Question type: Maintenance & Repair

I have a 1947 plymouth not original. It has a chevy 350 motor and a 12 volt system. I took out the original gauges and replaced them with autometer gauges. They work fine. When I use the turn signal the needles on the oil water and voltage gagues jump with the signal light. The gas gauge is fine. I thought it could be a ground. The gauges work fine except for the needles jumping when the turn signal is on. So far I can't find a solution to this. It's really not a problem because as soon as the turn signal is off the gauges work fine. If I can correct it that would be better..
Any help would be appreciated.

2 Answers

papa answered 13 years ago

yes check grounds,make sure the flasher is not going bad.really dont worrie about it if it only happends with turn signals on.

Mark helpful

Your Answer:

Related Questions

Shortcuts

Search Plymouth Questions

CarGurus Experts

  • #1
    Jason Macneil
    Reputation
    1,520
  • #2
    joedirt56
    Reputation
    680
  • #3
    dandyoun
    Reputation
    510
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.