Change sensor and don't have the pull away power

Change sensor and don't have the pull away power 4 Answers

I have a Chevy pick ! Well I went to pull the oil stick and the oil look a little cloudy the truck does not smoke Got a can of Blue Devil head gasket sealer should I change the oil and put it in with the new oil? Sure would appreciate your help Bonnie 2 Answers

Do you change the oil and put the Blue Devil in!

i replaced my throttle positioning sensor. i may have to change the pressure sensor on my fuel tank. my service engine light is on and my truck stalls as if it is not getting any fuel.how do i bypass 4 Answers

tps replaced..if i start my truck and the service engine light is on my truck will stall out. if the service light is off the truck is fine. i know it is a sensor but how can i bypass it...if i keep ...

I recently change my O2 sensor on my 2000 chevy silverado. after replacing bank 1 and 2, I reset the it with the code reader. The check engine light went out but came back on again. Any idea? 24 Answers

My truck wont pass smog.The original code was PO300. It was random misfire, I was told. I ask my buddy who is a mechanic in Arizona he advise me to change O2 sensor in stream bank 1 & 2. And to rese...

I have a 2004 Chevy Silverado extended cab, 4.8 liter. I have had multiple issues with this vehicle, but the one I can't seem to solve is this: if I leave the truck sitting for a day, when I get in and start driving, about 5 miles down the road, it acts like it is being starved of fuel. The engine light starts blinking and there is no power even when i step on the gas fully. After a minute or two, it goes away and runs fine unless I let it sit for a couple days. I just replaced my fuel lines because they were rusted out but that didn't solve the problem. Any ideas anyone? 6 Answers

Engine light is always on and blinks on and off when problem occurs.