Asked by Avery113 Jan 19, 2016 at 03:01 PM about the 2003 Ford Expedition XLT
Question type: Maintenance & Repair
There is a roar after about thirty miles per our get
noises as you speed up a mechanic recently
replaced the drive shaft. I was told by other it the
rear gears , so I had it serviced with proper oils.
Can you help me diagnose this problem
There is a roar after about thirty miles per our get noises as you speed up a mechanic recently replaced the drive shaft. I was told by other it the rear gears , so I had it serviced with proper oi...
2003 Ford Expedition XLT
-
Maintenance & Repair
Hello, I have a 1999 Ford Expedition that I had the cooling system flushed less than a year and has never over heated before or after the service although the water has always been very rusty in color...
1999 Ford Expedition 4 Dr Eddie Bauer 4WD SUV
-
Maintenance & Repair
I have a 2004 4.6 v8 the vehicle runs great until its under stain like driving up a hill and trying to maintain highway speed . accompanied with the grinding noise you can feel a slight lurching un...
2004 Ford Expedition XLT 4WD
-
Maintenance & Repair
Rough idle and/or stall while stopping or stopped after engine is up to operating temperature. Changed camshaft position sensors and coil packs. Now the codes I am getting are: P0012, P0340, P0345...
2004 Ford Expedition XLT
-
Maintenance & Repair
'97 Ford Expedition XLT: Every now & then the door lock(s) go "nuts", it seems they are trying to "cycle", the knobs don't go up nor down but a "cycling" sound occurs in one or more of the door locks....
1997 Ford Expedition 4 Dr XLT 4WD SUV
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.