Trying to replace my 4x4 control module. The back screw is blocked by a wiring harness. How do I remove the wiring harness to get to the screw?
2002 Ford Explorer
Asked by Gladiator_2378 Feb 09, 2017 at 02:26 PM about the 2002 Ford Explorer XLS 4WD
Question type: Maintenance & Repair
2002 Ford Explorer
Disconnect the connector to it if you can and pull it out of the way, a socket with wobblers may help you get past it, or use an offset open-end or box wrench. Just don't yank on the wires, you don't want to compound your problems. If you can get to any mounting clips for the wire harness unscrew those then you might have enough play to push it out of the way.
2002 Ford Explorer
2002 Ford Explorer XLS 4WD
-
Maintenance & Repair
How can i fix a broken screw from the alternator that the electrical wires connect to
1996 Ford Explorer 4 Dr XLT 4WD SUV
-
Maintenance & Repair
my explorer has 200,000 miles and still runs good but how do you replace the transmission fluid?
Ford Explorer
-
Maintenance & Repair
My 2012 Ford Explorer gives me the message "shift to park" when I turn off the car. The car is fully in park. I have to push the button on the gear shift and jiggle the gear shift for it to finally ac...
2012 Ford Explorer XLT 4WD
-
Maintenance & Repair
Searched for: 2002 explorer put new control modual in, disconnected the battery installed the part reconnected batt. now it is stuck in 4 wheel drive low, put old cm back in in. now pressing hi 4x4 or...
2002 Ford Explorer XLS
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.